All photos below are real parts machined in our shop — no stock or AI images.
Multi-Port Milled Component
多孔銑削件（客戶圖面）
Machined directly from a customer drawing — angled cross-ports, side slots and a fluted nose completed on a turn-mill in one setup.
Precision Stepped Shaft / Stem
精密階級軸 / 心軸
Multi-diameter shaft with a disc head and keyed slot end — mirror-turned with micron-level concentricity between steps.
2.5D Vision Inspection
2.5D 檢測設備
Every job is verified on a 2.5D vision measuring system — actual values checked against the tolerance band with pass/fail logged.
Stainless Connector / Coupler Body
不鏽鋼接頭 / 快接本體
Stainless coupler body with external thread, cross slot and a stepped through-bore — turned, milled and threaded in a single setup.
Volume Turned Fittings
量產車製接頭
Bar-fed automatic production of stainless fittings — thread, hex and profile held consistent across the full batch.
Knurled Control Knob
滾花控制旋鈕
Thumb knob with crisp diamond knurl, engraved index marks and an internal thread — clean machined detailing throughout.
Precision Stepped Bushing
精密階級襯套
Stepped sleeve / bushing with side holes — bore and OD held to tight tolerance and produced in consistent volume.
C1100 Copper Micro Part
C1100 紅銅微型零件
Bar-fed micro turning of C1100 copper parts featuring a Ø2.0 × Ø1.5 flat-bottom blind hole — high-volume small electrical / contact components.
Micro Turned Components
微型車製零件
High-volume micro components turned from bar — small diameters with threads and bores held consistent across thousands of pieces.